646 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Sample Configurations
VRRP for IPv4 Configuration
The configuration in Figure 38-19 shows how to enable IPv4 VRRP. This example does not contain
comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You
can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your
own IP addresses, interfaces, names, etc. Figure 38-19 shows the VRRP topology created with the CLI
configuration in Figure 38-20.
Task Command Syntax Command Mode
Set the delay time for VRRP initialization on an
individual interface. This is the gap between an
interface coming up and being operational, and
VRRP enabling.
Seconds range: 0-900
Default: 0
vrrp delay minimum seconds INTERFACE
Set the delay time for VRRP initialization on all
the interfaces in the system configured for
VRRP. This is the gap between system boot up
completion and VRRP enabling.
Seconds range: 0-900
Default: 0
vrrp delay reload seconds INTERFACE
To Next Page
Loading...
