Dell Force10 MXL Blade - Debug RIP; RIP Configuration Example

444 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
To view configuration changes, use the show config command in ROUTER RIP mode.
Debug RIP
To enable RIP debugging, use the debug ip rip command. When you enable debugging, you can view
information about RIP protocol changes or RIP routes (Figure 25-6).
To enable RIP debugging, use the following command in EXEC privilege mode:
Figure 25-6. debug ip rip Command Example
To disable RIP, use the no debug ip rip command.
RIP Configuration Example
The example in this section shows the command sequence to configure RIPv2 on the two routers shown in
Figure 25-7—“Core 2” and “Core 3”. The host prompts used in the example reflects those names. The
examples are divided into the following groups of command sequences:
• Configuring RIPv2 on Core 2
• Core 2 Output
• RIP Configuration on Core 3
• Core 3 RIP Output
• RIP Configuration Summary
Command Syntax Command Mode Purpose
debug ip rip [interface | database | events | trigger] EXEC privilege Enable debugging of RIP.
FTOS#debug ip rip
RIP protocol debug is ON
FTOS#