Dell Force10 MXL Blade - Configure FTP Client Parameters; Terminal Lines

Management | 63
Configure FTP Client Parameters
To configure FTP client parameters, use the following commands in CONFIGURATION mode:
To view FTP configuration, use the
show running-config ftp command in EXEC privilege mode (Figure 4-4).
Terminal Lines
You can access the system remotely and restrict access to the system by creating user profiles. The terminal
lines on the system provide different means of accessing the system. The virtual terminal lines (VTY)
connect you through Telnet to the system.
Deny and Permit Access to a Terminal Line
Dell Force10 recommends applying only standard access control lists (ACLs) to deny and permit access to
VTY lines.
• Layer 3 ACL deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with
no rules does not deny any traffic.
• You cannot use the
show ip accounting access-list command to display the contents of an ACL that is
applied only to a VTY line.
To apply an IP ACL to a line:
To view the configuration, enter the
show config command in LINE mode (Figure 4-5).
Command Syntax Command Mode Purpose
ip ftp source-interface interface CONFIGURATION Enter the following keywords and slot/port or number
information:
• For a loopback interface, enter the keyword loopback
followed by a number between 0 and 16383.
• For a port channel interface, enter the keyword
port-channel followed by a number from 1 to 128 For a
10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword
vlan followed
by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
ip ftp password
password
CONFIGURATION Configure a password.
ip ftp username name CONFIGURATION Enter username to use on FTP client.
Task Command Syntax Command Mode
Apply an ACL to a VTY line. ip access-class access-list LINE