Dell Force10 MXL Blade - Page 236

234 | Interfaces
www.dell.com | support.dell.com
• ip mtu (if the interface is on a Jumbo-enabled by default.)
To view the interface’s configuration, enter INTERFACE mode for that interface and use the
show config
command or from EXEC Privilege mode, use the
show running-config interface interface command.
To add a physical interface to a port channel, use these commands in the following sequence in
INTERFACE mode of a port channel:
To view the port channel’s status and channel members in a tabular format, use the
show interfaces
port-channel brief
command in EXEC Privilege mode (Figure 13-10).
Figure 13-10. show interfaces port-channel brief Command Example
Note: The MXL Switch supports jumbo frames by default (the default maximum transmission unit [MTU]
is 1554 bytes) You can configure the MTU using the
mtu command from INTERFACE mode.
Step Command Syntax Command Mode Purpose
1
channel-member interface
INTERFACE
PORT-CHANNEL
Add the interface to a port channel.
The interface variable is the physical interface
type and slot/port information.
2
show config
INTERFACE
PORT-CHANNEL
Double check that the interface was added to
the port channel.
FTOS#show int port brief
Codes: L - LACP Port-channel
LAG Mode Status Uptime Ports
1 L3 down 00:00:00 Te 0/16 (Down)
FTOS#