Dell Force10 MXL Blade - Page 253

Interfaces | 251
Figure 13-25. show interfaces status Command Example
In Figure 13-25, several ports display “Auto” in the Speed field, including port 0/1. In Figure 13-26, the
speed of port 0/1 is set to 100 Mb and then its auto-negotiation is disabled.
Figure 13-26. Setting Port Speed Example
FTOS#show interfaces status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Down Auto Auto --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Te 0/13 Down Auto Auto --
[output omitted]
FTOS#configure
FTOS(conf)#interface tengig 0/1
FTOS(Interface 0/1)#speed 100
FTOS(Interface 0/1)#duplex full
FTOS(Interface 0/1)#no negotiation auto
FTOS(Interface 0/1)#show config
!
interface TenGigabitEthernet 0/1
no ip address
speed 100
duplex full
no shutdown