Dell Force10 MXL Blade - Page 260

258 | Interfaces
www.dell.com | support.dell.com
To clear the counters, use the following command in EXEC Privilege mode:
When you enter this command, you must confirm that you want FTOS to clear the interface counters for
that interface (Figure 13-31).
Figure 13-31. Clearing an Interface
Command Syntax Command Mode Purpose
clear counters [interface]
[vrrp [vrid] | learning-limit]
EXEC Privilege Clear the counters used in the show interface commands for all
VRRP groups, VLANs, and physical interfaces or selected ones.
Without an interface specified, the command clears all interface
counters.
• (OPTIONAL) Enter the following interface keywords and slot/
port or number information:
• For a Loopback interface, enter the keyword loopback followed
by a number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094
• (OPTIONAL) Enter the keyword vrrp to clear statistics for all
VRRP groups configured. Enter a number from 1 to 255 as the
vrid.
• (OPTIONAL) Enter the keyword learning-limit to clear
unknown source address (SA) drop counters when MAC
learning limit is configured on the interface.
FTOS#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
FTOS#