Dell Force10 MXL Blade - Page 30

28 | Configuration Fundamentals
www.dell.com | support.dell.com
CONFIGURATION
FTOS(conf)# • From EXEC privilege mode, enter the command
configure.
• From every mode except EXEC and EXEC
Privilege, enter the command
exit.
Note: Access the following modes from CONFIGURATION mode:
INTERFACE modes
10 Gigabit Ethernet
Interface
FTOS(conf-if-te-0/1)
#
interface
40 Gigabit Ethernet
Interface
FTOS(conf-if-fo-0/33)
#
Interface Range
FTOS(conf-if-range)
#
Loopback Interface
FTOS(conf-if-lo-0)
#
Management Ethernet
Interface
FTOS(conf-if-ma-0/0)
#
Null Interface FTOS(conf-if-nu-0)#
Port-channel Interface FTOS(conf-if-po-1)#
VLAN Interface FTOS(conf-if-vl-1)#
Monitor Session FTOS(conf-mon-sess)
IP ACCESS-LIST
STANDARD ACCESS-
LIST
FTOS(conf-std-nacl)#
ip access-list standard
EXTENDED ACCESS-
LIST
FTOS(conf-ext-nacl)#
ip access-list extended
IP COMMUNITY-LIST
FTOS(conf-community-list)#
ip community-list
LINE
line
CONSOLE FTOS(conf-line-console)#
VIRTUAL TERMINAL FTOS(conf-line-vty)#
MAC ACCESS-LIST
STANDARD ACCESS-
LIST
FTOS(conf-std-macl)# mac access-list standard
EXTENDED ACCESS-
LIST
FTOS(conf-ext-macl)# mac access-list extended
MULTIPLE
SPANNING TREE
FTOS(conf-mstp)#
protocol spanning-tree mstp
Table 2-1. FTOS Command Modes
CLI Command Mode Prompt
Access Command