Dell Force10 MXL Blade - Page 448

446 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Figure 25-9. Example of RIP Configuration Response from Core 2
Figure 25-10. show ip route Command Example to Show RIP Configuration on Core 2
Core2(conf-router_rip)#end
00:12:24: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by console
Core2#show ip rip database
Total number of routes in RIP database: 7
10.11.30.0/24
[120/1] via 10.11.20.1, 00:00:03, TenGigabitEthernet 2/31
10.300.10.0/24 directly connected,TenGigabitEthernet 2/42
10.200.10.0/24 directly connected,TenGigabitEthernet 2/41
10.11.20.0/24 directly connected,TenGigabitEthernet 2/31
10.11.10.0/24 directly connected,TenGigabitEthernet 2/11
10.0.0.0/8 auto-summary
192.168.1.0/24
[120/1] via 10.11.20.1, 00:00:03, TenGigabitEthernet 2/31
192.168.1.0/24 auto-summary
192.168.2.0/24
[120/1] via 10.11.20.1, 00:00:03, TenGigabitEthernet 2/31
192.168.2.0/24 auto-summary
Core2#
Core2#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
C 10.11.10.0/24 Direct, TenGig 2/11 0/0 00:02:26
C 10.11.20.0/24 Direct, TenGig 2/31 0/0 00:02:02
R 10.11.30.0/24 via 10.11.20.1, TenGig 2/31 120/1 00:01:20
C 10.200.10.0/24 Direct, TenGig 2/41 0/0 00:03:03
C 10.300.10.0/24 Direct, TenGig 2/42 0/0 00:02:42
R 192.168.1.0/24 via 10.11.20.1, TenGig 2/31 120/1 00:01:20
R 192.168.2.0/24 via 10.11.20.1, TenGig 2/31 120/1 00:01:20
Core2#
R 192.168.1.0/24 via 10.11.20.1, TenGig 2/31 120/1 00:05:22
R 192.168.2.0/24 via 10.11.20.1, TenGig 2/31 120/1 00:05:22
Core2#