System Time and Date | 607
• end-week: If you entered a start-week, enter one of
the following as the week that daylight savings ends:
•
week-number: enter a number from 1 to 4 as the
number of the week to end daylight savings time.
•
first: enter the keyword first to end daylight savings
time in the first week of the month.
• last: enter the keyword last to end daylight savings
time in the last week of the month.
•
end-month: Enter the name of one of the 12 months in
English. You can enter the name of a day to change
the order of the display to
time day month year.
• end-day: Enter the number of the day. Range: 1 to 31.
You can enter the name of a day to change the order
of the display to time day month year.
• end-year: Enter a four-digit number as the year.
Range: 1993 to 2035.
• end-time: Enter the time in hours:minutes. For the
hour variable, use the 24-hour format, example, 17:15
is 5:15 pm.
• offset: (OPTIONAL) Enter the number of minutes to
add during the summer-time period. Range: 1 to1440.
Default: 60 minutes
Note: If you enter <CR> after entering the recurring command parameter, and you have already set a one-time
daylight saving time/date, the system uses that time and date as the recurring setting.
Command Syntax Command Mode Purpose
FTOS(conf)#clock summer-time pacific recurring Mar 14 2012 00:00 Nov 7 2012 00:00
FTOS(conf)#
FTOS(conf)#clock summer-time pacific recurring ?
<1-4> Week number to start
first Week number to start
last Week number to start
<cr>
FTOS(conf)#clock summer-time pacific recurring
FTOS(conf)#
To Next Page
Loading...
