BigIron RX Series Configuration Guide 989
53-1002253-01
Sample 802.1x configurations
33
Displaying information about the ports in an 802.1x multiple client configuration
To display information about the ports in an 802.1x multiple client configuration, enter the
following command.
Syntax: show dot1x mac-session brief [ | begin <expression> | exclude <expression> | include
<expression>]
The following table describes the information displayed by the show dot1x mac-session brief
command.
Sample 802.1x configurations
This section illustrates a sample point-to-point configuration and a sample hub configuration that
use 802.1x port security.
ACL Whether or not an IP ACL is applied to incoming (i) and outgoing (o)
traffic on the interface
MAC Whether or not a MAC filter is applied to the port.
Age The software age of the dot1x-mac-session.
TABLE 164 Output from the show dot1x mac-session brief command
This field... Displays...
Port Information about the users connected to each port.
Number of users The number of restricted and authorized (those that were successfully
authenticated) users connected to the port.
Dynamic VLAN Whether or not the port is a member of a RADIUS-specified VLAN.
Dynamic ACL Whether or not a RADIUS-specified ACL has been applied to the port for
incoming (in) and outgoing (out) traffic.
Dynamic MAC Filters Whether or not a RADIUS-specified MAC Filter has been applied to the
port.
TABLE 163 Output from the show dot1x mac-session command (Continued)
This field... Displays...
BigIron RX# show dot1x mac-session brief
Port Number of users Dynamic Dynamic Dynamic
Restricted Authorized Total VLAN ACL(In/Out) MAC-Filt
---------+----------+----------+-----+-------+-----------+--------
1/1 0 0 1 no no/no no
1/2 0 1 1 yes yes/no no
1/3 0 1 1 yes yes/no no
1/4 0 1 1 yes yes/no no
1/5 0 1 1 yes yes/no no
To Next Page
Loading...
