Dell PowerConnect B-RX - Port-Based Routing; Quality of Service (Qos)

BigIron RX Series Configuration Guide 1359
53-1002253-01
Port-based routing
E
Port-based routing
Quality of Service (QoS)
port-name <text> “Assigning a port name” on page 139
qd-flow sink <sinking-threshold> sunk <sunk-threshold>
slot <slot>
“Specifying threshold values for flow control” on
page 142
set mirror-interface
<slot number>/<port number>
“Configuring mirror ports for PBR traffic” on
page 150
show monitor actual “Displaying mirror and monitor port configuration” on
page 150
show monitor config “Displaying mirror and monitor port configuration” on
page 150
speed-duplex <value> “Speed/Duplex negotiation” on page 140
Commands See ...
Commands See ...
access-list <num> deny | permit <source-ip> |
<hostname> <wildcard>
“Configure the ACLs” on page 574
access-list <num> deny | permit
<source-ip>/<mask-bits> | <hostname>
access-list <num> deny | permit any
access-list <num> deny | permit host <source-ip> |
<hostname>
ip policy route-map <map-name> “Enabling PBR” on page 576
match ip address
<ACL-num-or-name>
“Configure the route map” on page 575
route-map <map-name>
permit | deny <num>
“Configure the route map” on page 575
“Basic example” on page 577
set interface null0 “Configure the route map” on page 575
set ip next hop <ip-addr> “Configure the route map” on page 575
“Basic example” on page 577
Commands See ...
dscp <num> “Configuring DSCP classification by interface” on
page 480
priority <num> “Changing a port’s priority” on page 481
“Changing a Layer 2 port-based VLAN’s priority” on
page 481
qos multicast best-effort rate <rate> “Configuring multicast traffic engineering” on
page 498