Dell PowerConnect B-RX - Displaying Summary MBGP Information; Displaying the Active MBGP Configuration

BigIron RX Series Configuration Guide 1193
53-1002253-01
Displaying IPv6 MBGP information
46
Displaying summary MBGP information
To display summary MBGP information, enter the following command at any CLI prompt.
Syntax: show ipv6 mbgp summary
NOTE
This command’s display looks similar to the display for the show ipv6 bgp config command.
However, the show ipv6 mbgp config command lists only the MBGP neighbors, whereas the show
ipv6 bgp config command lists only the BGP neighbors.
Displaying the Active MBGP Configuration
To display the active MBGP configuration information contained in the running-config without
displaying the entire running-config, enter the following command at any level of the CLI.
show ipv6 mbgp dampened-paths Displays IPv6 MBGP paths that have been dampened by route flap
dampening.
show ipv6 mbgp flap-statistics Displays route flap dampening statistics.
show ipv6 mbgp filtered-routes Displays routes that have been filtered out.
TABLE 209 IPv6 MBGP Show commands (Continued)
Command Description
BigIron RX# show ipv6 mbgp summary
BGP4 Summary
Router ID: 9.9.9.1 Local AS Number : 200
Confederation Identifier : not configured
Confederation Peers:
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 5677
Number of Routes Advertising to All Neighbors : 5673
Number of Attribute Entries Installed : 3
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
166.1.1.2 200 ESTAB 0h24m54s 3 0 5673 0