EasyManua.ls Logo

Dell PowerConnect B-RX - Qos Options for IP Acls

Dell PowerConnect B-RX
1458 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
564 BigIron RX Series Configuration Guide
53-1002253-01
QoS options for IP ACLs
21
When the first Syslog entry for a packet denied by an ACL is generated, the software starts an ACL
timer. After this, the software sends Syslog messages every 1 to 10 minutes, depending on the
value of the timer interval. If an ACL entry does not permit or deny any packets during the timer
interval, the software does not generate a Syslog entry for that ACL entry.
NOTE
For an ACL entry to be eligible to generate a Syslog entry for denied packets, logging must be
enabled for the entry. The Syslog contains entries only for the ACL entries that deny packets and
have logging enabled.
To display Syslog entries, use one of the following methods.
Enter the following command from any CLI prompt.
QoS options for IP ACLs
QoS options enable you to perform QoS for packets that match the ACLs. Using an ACL to perform
QoS is an alternative to the following methods.
Directly setting the internal forwarding priority based on incoming port, VLAN membership, and
so on. (This method is described in Assigning QoS priorities to traffic” on page 466.)
Enabling the IP ToS-based QoS feature described in “Configuring ToS-based QoS” on page 468.
NOTE
If you use an ACL on an interface, ToS-based QoS assumes that the ACL will perform QoS for all
packets except the packets that match the permit ip any any ACL.
For a list of supported QoS ACL options refer to “Using ACL QoS options to filter packets” on
page 537
BigIron RX(config)# show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 38 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Oct 13 16:24:29:N:Switch Fabric 5 temperature 59.875 C degrees is normal
Dynamic Log Buffer (50 lines):Oct 13 17:19:36:I:running-config was changed from
telnet client 192.168.9.181
Oct 13 17:06:18:I:running-config was changed from telnet client 192.168.9.181
Oct 13 16:57:44:I:ACL: entry modified from telnet session
Oct 13 16:57:40:I:ACL: entry modified from telnet session
Oct 13 16:57:32:I:ACL: entry added from telnet session
Oct 13 16:53:04:I:ACL: 10 modified from telnet session
.
.
.

Table of Contents

Other manuals for Dell PowerConnect B-RX

Related product manuals