Dell PowerConnect B-RX - Appendix D Commands that Require a Reload; Index to the CLI Commands; Appendix E Index to the CLI Commands; Acls (IP)

BigIron RX Series Configuration Guide 1329
53-1002253-01
Appendix
E
Index to the CLI Commands
This appendix lists the CLI commands discussed in this configuration guide. Look for the CLI
command alphabetically by feature. You can also use your browser’s search function to find the
command you want. When you find the command, click on the link to display the section that
discusses that command.
ACLs (IP)
Numbered ACL
Commands See ...
access-list <num> deny | permit <ip-protocol>
<source-ip> | <hostname> <wildcard> [<operator>
<source-tcp/udp-port>] <destination-ip> | <hostname>
<wildcard> [<operator> <destination-tcp/udp-port>]
[match-all <tcp-flags>] [match-any <tcp-flags>]
[<icmp-type>] [established] [precedence <name> |
<num>]
[tos <number>] [dscp-matching <number>]
[802.1p-priority-matching <number>] [dscp-marking
<number> 802.1p-priority-marking <number>
internal-priority-marking <number>] | [dscp-marking
<number> dscp-cos-mapping] | [dscp-cos-mapping]
[fragment] [non-fragment] [first-fragment] [fragment-offset
<number>] [spi <00000000 - ffffffff>] [log]
“Configuring extended numbered ACLs” on page 531
“Enabling ACL filtering of fragmented or
non-fragmented packets” on page 568
access-list <num> deny | permit host <ip-protocol> any
any [log]
access-list <num> deny | permit icmp any any [log]
<icmp-type> | <type-number> <code-number>
“ICMP filtering for extended ACLs” on page 569
access-list <num> deny | permit any I <source-ip>
|<source-ip>/<mask-bits> | <hostname> <wildcard>
[log]
“Configuring standard numbered ACLs” on page 529
access-list <acl-num> remark [<comment-text>
] “Numbered ACLs: adding a comment” on page 558
“Numbered ACLs: deleting a comment” on page 559
no access-list <acl-number>
<entire-deny-or-permit-statement>
“Deleting ACL entries” on page 560
show access-list <acl-num> | all “Displaying ACL definitions” on page 544