Dell PowerConnect B-RX - Displaying the Configured OSPF Area Prefix List; Modifying OSPF Traps Generated

716 BigIron RX Series Configuration Guide
53-1002253-01
Configuring OSPF
25
Displaying the configured OSPF area prefix list
To display the prefix-lists attached to the areas, enter the following command.
BigIron RX(config)#show ip ospf config
Router OSPF: Enabled
Graceful Restart: Disabled, timer 120
Graceful Restart Helper: Enabled
Redistribution: Disabled
Default OSPF Metric: 10
OSPF Auto-cost Reference Bandwidth: Disabled
OSPF Redistribution Metric: Type2
OSPF External LSA Limit: 14447047
OSPF Database Overflow Interval: 0
RFC 1583 Compatibility: Enabled
Router id: 5.5.5.1
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled
Interface Configuration Error Trap: Enabled
Virtual Interface Configuration Error Trap: Enabled
Interface Authentication Failure Trap: Enabled
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap: Enabled
Virtual Interface Receive Bad Packet Trap: Enabled
Interface Retransmit Packet Trap: Disabled
Virtual Interface Retransmit Packet Trap: Disabled
Originate LSA Trap: Disabled
Originate MaxAge LSA Trap: Disabled
Link State Database Overflow Trap: Disabled
Link State Database Approaching Overflow Trap: Disabled
OSPF Area currently defined:
Area-ID Area-Type Cost Prefix List In Prefix List Out
0 normal 0
1 normal 0 Area_1_Pfx_list in Area_1_Pfx_List_Out
Syntax: show ip ospf config
DIsplaying the configured IP prefix list
To only display the configured ip prefix-list, enter a command such as the following.
BigIron RX# show ip prefix-lists
ip prefix-list abc: 2 entries
seq 5 deny 2.3.4.0/24
seq 10 permit 4.5.0.0/16.
Syntax: show ip prefix-lists <prefix-list-name>
The <prefix-list-name> parameter specifies the name of the prefix list. You use this name when
applying the prefix list to an area.
Modifying OSPF traps generated
OSPF traps as defined by RFC 1850 are supported on BigIron RX.
You can enable or disable OSPF trap generation by doing the following.