BigIron RX Series Configuration Guide 1371
53-1002253-01
Redundant management module
E
Redundant management module
show port security statistics <portnum> I <module> “Displaying MAC Port Security statistics” on
page 958
shutdown-time <minutes> “Interface shutdown time” on page 956
violation restrict “Restricting interface access” on page 952
violation shutdown “Shutdown the interface” on page 952
Commands See ...
Commands See ...
active-management <mgt-module> “Changing the default active slot” on page 29
sync-standby “Comparing and synchronizing files” on page 31
force-sync-standby “Synchronizing files without comparison” on page 32
switchover “Manually switching over to the standby
management module” on page 32
reset “Manually switching over to the standby
management module” on page 32
boot system bootp | [flash primary | flash secondary] |
slot <number> <filename> | tftp <ip-address>
<filename>
“Rebooting the active and standby management
modules” on page 32
reload “Rebooting the active and standby management
modules” on page 32
reboot-standby “Rebooting the active and standby management
modules” on page 32
show module “Determining management module status” on
page 33
show chassis “Displaying temperature information” on page 34
format slot1 | slot2 “Formatting a flash card” on page 40
pwd “Determining the current management focus” on
page 41
cd <directory-pathname> “Switching the management focus” on page 41
chdir <directory-pathname> “Switching the management focus” on page 41
dir | ls [<path-name>] “Displaying a directory of the files” on page 42
more [/<directory>/]<file-name> “Displaying the contents of a file” on page 44
hd [/<directory>/]<file-name> “Displaying the hexadecimal output of a file” on
page 45
md | mkdir [slot1 | slot2] <dir-name> “Creating a subdirectory” on page 45
rd | rmdir [slot1 | slot2] <dir-name> “Removing a subdirectory” on page 47
rename | mv [/<directory>/]<old-file-name>
[/<directory>/]<new-file-name>
“Renaming a file” on page 48
To Next Page
Loading...
