BigIron RX Series Configuration Guide lxix
53-1002253-01
Network management
Enhancements in release 02.2.01
Hardware enhancements
Layer 2 enhancements
TABLE 19 Network management
Enhancement Description See...
IPv6 Management TFTP, SSH,
Telnet, AAA, and WEB
You can perform system management tasks for
the BigIron RX using the TFTP, telnet, AAA, and
Secure Shell (SSH).
Book: BigIron RX Series
Configuration Guide
Chapter:“Configuring Basic
IPv6 Connectivity”
TABLE 20 Hardware enhancements
Enhancement Description See page
New Hardware Support The following new hardware is supported with the
02.2.01 software release for the BigIron RX:
• Management module with 2 GB of memory
• 24-port 100/1000 Mbps SFP Ethernet interface
module
• 48-port 1 Gbps Copper Ethernet interface module
• DC Power Supply
• New fan controller
Book: Brocade BigIron RX
Series Installation Guide
TABLE 21 Layer 2 enhancements
Enhancement Description See page
VLAN Byte Accounting With this release, you can configure a VLAN to account
for the number of bytes received by all the member
ports.
Book: BigIron RX Series
Configuration Guide
Chapter:“VLANs”
Section:“VLAN byte
accounting”
Super Aggregated VLANs
(SAV)
Multiple VLANs can be aggregated within another VLAN
to allow you to construct Layer 2 paths and channels.
Book: BigIron RX Series
Configuration Guide
Chapter:“VLANs”
Section:“Configuring
super aggregated VLANs”
Enhancement to the lacp
system-priority command
The lacp system-priority command has been moved
from the interface configuration level to the global
configuration level.
Book: BigIron RX Series
Configuration Guide
Chapter: See the
Dynamic Link
Aggregation chapter in
the BigIron RX Series
Configuration Guide -
Versions 02.5.00 and
earlier.
Section:Configuring Link
Aggregation Parameters