BigIron RX Series Configuration Guide 1373
53-1002253-01
SNMP
E
SNMP
copy tftp running-config <ip-addr>
[/<from-dir-path>/]<from-name> [overwrite]
“Loading a running-config from a flash card or a TFTP
server” on page 55
cp [<source-dir-path>]<source-file-name>
[<dest-dir-path>]<dest-file-name>
“Copying files using the cp command” on page 56
boot system slot1 | slot2 [/<dir-path>/]<file-name> “Rebooting from the system” on page 57
boot system tftp <ip-address> <file-name> “Rebooting from the system” on page 57
boot system flash secondary “Rebooting from the system” on page 57
boot system slot1 <file-name> | slot2 <file-name> | flash
secondary | tftp <ip-address> <file-name> | bootp
“Configuring the boot source for future reboots” on
page 58
locate startup-config “Displaying the current location for saving
configuration changes” on page 58
locate startup-config [slot1 | slot2 | flash-memory]
[/<dir-path-name>/]<file-name>
“Specifying the location for saving configuration
changes” on page 58
Commands See ...
Commands See ...
show snmp engineid “Displaying the engine ID” on page 1019
show snmp group “Defining an SNMP group” on page 1016
show snmp server “Displaying the SNMP community strings” on
page 1014
show snmp user “Displaying user information” on page 1020
snmp-server community [0] <string>
ro | rw [view <viewname>] [<standard-acl-name> |
<standard-acl-id> | ipv6 <ipv6-access-list-name>]
“Adding an SNMP community string” on page 1013
snmp-server engineid local <hex-string> “Defining the engine ID” on page 1016
snmp-server group <groupname>
v1 | v2c | v3
auth | noauth | priv
[access <standard-acl-id>] [read <viewstring>] [write
<viewstring>]
“Displaying SNMP groups” on page 1019
snmp-server user <name> <groupname> v3
[[access <standard-acl-id>]
[[encrypted] auth md5 <md5-password> | sha
<sha-password> [priv [encrypted] des <des-password>]]]
“Defining an SNMP user account” on page 1017
snmp-server view <name> <mib_tree> included |
excluded
“Defining SNMP views” on page 1020
To Next Page
Loading...
