Dell PowerConnect B-RX - Redistributing RIP Routes into Ipv4 IS-IS; Redistributing OSPF Routes into Ipv4 IS-IS; Redistributing BGP4+ Routes into Ipv4 IS-IS

BigIron RX Series Configuration Guide 885
53-1002253-01
Configuring IPv4 address family route parameters
28
Redistributing RIP routes into IPv4 IS-IS
To redistribute RIP routes into IPv4 IS-IS, enter the following command at the IPv4 IS-IS unicast
address family configuration level.
BigIron RX(config-isis-router-ipv4u)# redistribute rip
This command configures the device to redistribute all RIP routes into Level-2 IS-IS.
Syntax: [no] redistribute rip [level-1 | level-1-2 | level-2] | metric <number> | metric-type [external
| internal] | route-map <name>
The parameters are the same as the parameters for the redistribute static command.
Redistributing OSPF routes into IPv4 IS-IS
To redistribute OSPF routes into IPv4 IS-IS, enter the following command at the IPv4 IS-IS unicast
address family configuration level.
BigIron RX(config-isis-router-ipv4u)# redistribute ospf
This command configures the device to redistribute all OSPF routes into Level-2 IPv4 IS-IS.
Syntax: [no] redistribute ospf [level-1 | level-1-2 | level-2] |
match [external1 | external2 | internal] |
metric <number> |
metric-type [external | internal] |
route-map <name>
Most of the parameters are the same as the parameters for the redistribute static command.
However, the redistribute ospf command also has the match external1 | external2 | internal
parameter. This parameter specifies the OSPF route type you want to redistribute into IPv4 IS-IS. By
default, the redistribute ospf command redistributes only internal routes.
• external1 – An OSPF type 1 external route.
• external2 – An OSPF type 2 external route.
• internal – An internal route calculated by OSPF.
Redistributing BGP4+ routes into IPv4 IS-IS
To redistribute BGP4+ routes into IPv4 IS-IS, enter the following command at the IPv4 IS-IS unicast
address family configuration level.
BigIron RX(config-isis-router-ipv4u)# redistribute bgp
This command configures the router to redistribute all its BGP4 routes into Level-2 IPv4 IS-IS.
Syntax: [no] redistribute bgp [level-1 | level-1-2 | level-2] |
metric <number> | metric-type [external | internal] |
route-map <name>
The parameters are the same as the parameters for the redistribute static command.