Dell PowerConnect B-RX - Ipv6 Ospfv3

BigIron RX Series Configuration Guide 1349
53-1002253-01
IPv6 OSPFv3
E
IPv6 OSPFv3
show ipv6 rip route [<ipv6-prefix>/<prefix-length> |
<ipv6-address>]
“Displaying RIPng routing table” on page 1127
timers <update-timer> <timeout-timer>
<hold-down-timer> <garbage-collection-timer>
“Configuring RIPng timers” on page 1122
Commands See ...
Commands See ...
area <number> | <ipv4-address> “Assigning OSPFv3 areas” on page 1211
area <number> | <ipv4-address> stub <metric>
[no-summary]
“Assigning a totally stubby area” on page 1212
area <number> | <ipv4-address> virtual-link <router-id> “Configuring virtual links” on page 1213
area <number> | <ipv4-address> virtual-link <router-id>
[dead-interval <seconds> | hello-interval <seconds> |
retransmit-interval <seconds> | transmit-delay
<seconds>]
“Modifying virtual link parameters” on page 1214
auto-cost reference-bandwidth <number> “Changing the reference bandwidth for the cost on
OSPFv3 interfaces” on page 1215
auto-cost reference-bandwidth <number> “Modifying exit overflow interval” on page 1225
default-information-originate [always] [metric <value>]
[metric-type <type>]
“Configuring default route origination” on page 1222
default-metric <number> “Modifying default metric for routes redistributed into
OSPF version 3” on page 1218
distance external | inter-area | intra-area <distance> “Configuring administrative distance based on route
type” on page 1224
distribute-list prefix-list <name> in [<interface>] “Configuring an OSPFv3 distribution list using an IPv6
prefix list as input” on page 1220
distribute-list route-map <name> in “Configuring an OSPFv3 distribution list using an IPv6
prefix list as input” on page 1220
external-lsdb-limit <entries> “Modifying external link state database limit” on
page 1225
ipv6 ospf area <number> | <ipv4-address> “Assigning interfaces to an area” on page 1212
ipv6 prefix-list
<name> [seq <seq-value>] [description
<string>] deny | permit <ipv6-addr>/<mask-bits> [ge
<ge-value>] [le <le-value>]
“Configuring an OSPFv3 distribution list using a route
map as input” on page 1222
pv6 router ospf “Enabling OSPFv3” on page 1210
log-status-change “Disabling or reenabling event logging” on page 1227
metric-type type1 | type2 “Modifying metric type for routes redistributed into
OSPF version 3” on page 1218
redistribute bgp | connected | isis [level-1 | level-1-2 |
level-2] | rip | static [metric <number> | metric-type
<type>]
“Redistributing routes into OSPFv3” on page 1216