Dell PowerConnect B-RX - Port Parameters

1358 BigIron RX Series Configuration Guide
53-1002253-01
Port parameters
E
Port parameters
show ip ospf database link-state [advertise <num>] |
[asbr] | [extensive] | [link-state-id <ip-addr>] | [network] |
[nssa] | [router] | [router-id <ip-addr>] |
[sequence-number <num(Hex)>] | [summary]
“Displaying OSPF database link state information” on
page 730
show ip ospf interface [<ip-addr>] “Displaying OSPF interface information” on page 725
show ip ospf neighbor
[router-id <ip-addr>] | [<num>]
“Displaying OSPF neighbor information” on page 724
show ip ospf redistribute route
[<ip-addr> <ip-mask>]
“Displaying the routes that have been redistributed
into OSPF” on page 728
show ip ospf routes [<ip-addr>] “Displaying OSPF route information” on page 727
show ip ospf trap “Displaying OSPF trap status” on page 732
show ip ospf virtual link [<num>] “Displaying OSPF virtual link information” on
page 734
show ip ospf virtual neighbor [<num>] “Displaying OSPF virtual neighbor and link
information” on page 732
show tasks “Displaying CPU utilization and other OSPF tasks” on
page 721
snmp-server trap ospf <ospf-trap> “Modifying OSPF traps generated” on page 716
summary-address <ip-addr> <ip-mask> “Configure external route summarization” on
page 708
timers lsa-group-pacing <secs> “Changing the LSA pacing interval” on page 713
timers spf <delay> <hold-time> “Modify SPF timers” on page 711
Commands See ...
Commands See ...
config-trunk-ind “Monitoring an individual trunk port” on page 148
disable “Disabling or re-enabling a port” on page 141
enable “Disabling or re-enabling a port” on page 141
flow-control “Disabling or re-enabling flow control” on page 142
gig-default neg-full-auto | auto-gig | neg-off “Changing the default Gigabit negotiation mode” on
page 141
“Changing the default Gigabit negotiation mode” on
page 141
ip address <ip-addr> <ip-mask> | <ip-addr>/<mask-bits> “Assigning an IP address to a port” on page 139
lock-address ethernet <portnum> [addr-count <num>] “Locking a port to restrict addresses” on page 143
monitor
ethe-port-monitored <portnum> | named-port-monitored
<portname> ethernet | <portnum>
in | out | both
“Monitoring an individual trunk port” on page 148
phy-mode wan “Enabling WAN PHY mode support” on page 151