Dell PowerConnect B-RX - Topology

BigIron RX Series Configuration Guide 1377
53-1002253-01
Topology
E
Topology
show default values “Displaying and modifying system parameter default
settings” on page 130
show logging “Examples of Syslog messages for CLI access” on
page 121
show sntp associations “Specifying a Simple Network Time Protocol (SNTP)
server” on page 124
show sntp status “Specifying a Simple Network Time Protocol (SNTP)
server” on page 124
show terminal “Checking the length of terminal displays” on
page 129
snmp-server contact <string> “Entering system administration information” on
page 117
snmp-server enable traps
<trap-type>
“Disabling SNMP traps” on page 120
snmp-server enable traps holddown-time <secs> “Setting the SNMP Trap holddown time” on page 119
snmp-server host <ip-addr> [0 | 1] <string> [port <value>] “Specifying an SNMP trap receiver” on page 118
snmp-server location <string> “Entering system administration information” on
page 117
snmp-server trap-source loopback <num> | ethernet
<slot/port> | ve <num>
“Specifying a Single trap source” on page 119
sntp poll-interval <1-65535> “Specifying a Simple Network Time Protocol (SNTP)
server” on page 124
sntp server <ip-addr> | <hostname> [<version>] “Specifying a Simple Network Time Protocol (SNTP)
server” on page 124
static-mac-address <mac-addr> ethernet <portnum> [to
<portnum> ethernet <portnum>]
[priority <number>] [host-type | router-type | fixed-host]
“Assigning static MAC address entries to priority
queues” on page 481
system-max ip-static-route <num> “Displaying and modifying system parameter default
settings” on page 130
system-max subnet-per-interface <num> “Displaying and modifying system parameter default
settings” on page 130
system-max subnet-per-system <num> “Displaying and modifying system parameter default
settings” on page 130
terminal length <number-of-lines> “Configuring terminal display” on page 129
unknown-unicast limit <number> “NP based multicast, broadcast, and
unknown-unicast rate limiting” on page 513
Commands See ...
Commands See ...
master-vlan <vlan-id> “Configuring a topology group” on page 449
member-group <num> “Configuring a topology group” on page 449