1326 BigIron RX Series Configuration Guide
53-1002253-01
Local user password changes
C
Local user password changes
Please note that if existing usernames and passwords have been configured on a Brocade device
with specific privilege levels (super-user, read-only, port-config) and if you attempt to change a
user's password by executing the following syntax.
BigIron RX(config)# user brcdreadonly password <value>
The privilege level of this particular user will be changed from its current value to "super-user". The
“super-user” level username and password combination provides full access to the Brocade
command line interface (CLI). To prevent this from occurring, use the following syntax.
BigIron RX(config)# user brcdreadonly privilege <value> password <value>
To Next Page
Loading...
