Dell PowerConnect B-RX - Clearing the RIP Routes from the Routing Table

BigIron RX Series Configuration Guide 677
53-1002253-01
Displaying RIP filters
24
Clearing the RIP routes from the routing table
Clearing all the routes from the routing table
To clear RIP local routes, enter a command such as the following.
BigIron RX(config)#clear ip rip local routes
Syntax: clear ip rip local routes
To clear the RIP routes from the RIP database, enter a command such as the following.
BigIron RX(config)# clear ip rip routes
Syntax: clear ip rip routes <ip-addr> / <mask-bits>
Use the ip address to specify which routes in the database you want to clear.
Use the subnet mask to specify which subnets you want to clear.
NOTE
Using the clear ip route command will not clear routes learned through RIP.