Dell PowerConnect B-RX - Displaying Ripng Configuration; Displaying Ripng Routing Table

BigIron RX Series Configuration Guide 1127
53-1002253-01
Displaying RIPng information
44
• RIPng routing table
Displaying RIPng configuration
To display RIPng configuration information, enter the following command at any CLI level.
Syntax: show ipv6 rip
This display shows the following information:
Displaying RIPng routing table
To display the RIPng routing table, enter the following command at any CLI level.
TABLE 185 RIPng configuration fields
This field... Displays...
IPv6 RIP status/port The status of RIPng on the Brocade device. Possible status is “enabled” or
“disabled.”
The UDP port number over which RIPng is enabled.
Administrative distance The setting of the administrative distance for RIPng.
Updates/expiration The settings of the RIPng update and timeout timers.
Holddown/garbage collection The settings of the RIPng hold-down and garbage-collection timers.
Split horizon/poison reverse The status of the RIPng split horizon and poison reverse features. Possible
status is “on” or “off.”
Default routes The status of RIPng default routes.
Periodic updates/trigger updates The number of periodic updates and triggered updates sent by the RIPng
router.
Distribution lists The inbound and outbound distribution lists applied to RIPng.
Redistribution The types of IPv6 routes redistributed into RIPng. The types can include the
following:
• STATIC – IPv6 static routes are redistributed into RIPng.
• CONNECTED – Directly connected IPv6 networks are redistributed into
RIPng.
• BGP – BGP4+ routes are redistributed into RIPng.
• ISIS – IPv6 IS-IS routes are redistributed into RIPng.
• OSPF – OSPFv3 routes are redistributed into RIPng.
BigIron RX# show ipv6 rip
IPv6 rip enabled, port 521
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 0, trigger updates 0
Distribute List, Inbound : Not set
Distribute List, Outbound : Not set
Redistribute: CONNECTED