Dell PowerConnect B-RX - Redistributing Routes into Ospfv3

1216 BigIron RX Series Configuration Guide
53-1002253-01
Configuring OSPFv3
48
• 1000 Mbps port’s cost = 500/1000 = 0.5, which is rounded up to 1
• 155 Mbps port’s cost = 500/155 = 3.23, which is rounded up to 4
• 622 Mbps port’s cost = 500/622 = 0.80, which is rounded up to 1
• 2488 Mbps port’s cost = 500/2488 = 0.20, which is rounded up to 1
The costs for 10 Mbps, 100 Mbps, and 155 Mbps ports change as a result of the changed
reference bandwidth. Costs for higher-speed interfaces remain the same.
Syntax: [no] auto-cost reference-bandwidth <number>
The <number> parameter specifies the reference bandwidth and can be a value from 1 –
4294967. The default is 100.
To restore the reference bandwidth to its default value and thus restore the default costs of
interfaces to their default values, enter the no form of this command.
Redistributing routes into OSPFv3
In addition to specifying which routes are redistributed into OSPFv3, you can configure the following
aspects related to route redistribution:
• Default metric
• Metric type
• Advertisement of an external aggregate route
Configuring route redistribution into OSPFv3
You can configure the Brocade device to redistribute routes from the following sources into
OSPFv3:
• IPv6 static routes
• Directly connected IPv6 networks
• BGP4+
• IPv6 IS-IS
• RIPng
You can redistribute routes in the following ways:
• By route types, for example, the Brocade device redistributes all IPv6 static and RIPng routes.
• By using a route map to filter which routes to redistribute, for example, the Brocade device
redistributes specified IPv6 static and RIPng routes only.
For example, to configure the redistribution of all IPv6 static,RIPng, and IPv6 IS-IS level-1 and
level-2 routes, enter the following commands.
BigIron RX(config-ospf6-router)# redistribute static
BigIron RX(config-ospf6-router)# redistribute rip
BigIron RX(config-ospf6-router)# redistribute isis level-1-2
Syntax: [no] redistribute bgp | connected | isis [level-1 | level-1-2 | level-2] | rip | static [metric
<number> | metric-type <type>]
The bgp | connected | isis | rip | static keywords specify the route source.