Dell PowerConnect B-RX - Vsrp

BigIron RX Series Configuration Guide 1381
53-1002253-01
VSRP
E
VSRP
router vrrp “Configuring the owner” on page 460
“Configuring a backup” on page 461
“VRRP example” on page 473
router vrrp-extended “Configuring parameters specific to VRRPE” on
page 462
show ip vrrp | vrrp-extended
[brief | ethernet <portnum> | ve <num> | stat]
“Displaying summary information” on page 467
“Displaying detailed information” on page 469
“Displaying statistics” on page 472
track-port ethernet <portnum> I ve <num> “Track port” on page 465
“VRRPE example” on page 475
use-vrrp-path “Suppression of RIP advertisements on backup
routers for the backup up interface” on page 464
Commands See ...
Commands See ...
backup [priority <value>] [track-priority <value>] “Configuring basic VSRP parameters” on page 431
“Changing the backup priority” on page 435
“Changing the default track priority” on page 438
enable | disable “Configuring basic VSRP parameters” on page 431
include-port ethernet <portnum> “Adding or removing a port from the VRID’s VLAN” on
page 433
initial-ttl <num> “Changing the Time-To-Live (TTL)” on page 436
ip-address <ip-addr> “Configuring a VRID IP address” on page 433
ip vsrp auth-type no-auth I
simple-text auth <auth-data>
“Configuring authentication” on page 432
non-preempt-mode “Disabling or re-enabling backup pre-emption” on
page 439
show vsrp [vrid <num> | vlan <vlan-id>] “Displaying VRID information” on page 442
show vsrp aware “Displaying the active interfaces for a VRID” on
page 446
track-port ethernet <portnum> I ve <num> [priority
<num>]
“Specifying a track port” on page 439
vsrp vrid <num> “Configuring basic VSRP parameters” on page 431