Dell PowerConnect B-RX - Modify OSPF Standard Compliance Setting

718 BigIron RX Series Configuration Guide
53-1002253-01
Configuring OSPF
25
• virtual-interface-config-error-trap – [MIB object: ospfVirtIfConfigError]
• interface-authentication-failure-trap – [MIB object: ospfIfAuthFailure]
• virtual-interface-authentication-failure-trap – [MIB object: ospfVirtIfAuthFailure]
• interface-receive-bad-packet-trap – [MIB object: ospfIfrxBadPacket]
• virtual-interface-receive-bad-packet-trap – [MIB object: ospfVirtIfRxBadPacket]
The following traps are disabled by default:
• interface-retransmit-packet-trap – [MIB object: ospfTxRetransmit]
• virtual-interface-retransmit-packet-trap – [MIB object: ospfVirtIfTxRetransmit]
• originate-lsa-trap – [MIB object: ospfOriginateLsa]
• originate-maxage-lsa-trap – [MIB object: ospfMaxAgeLsa]
• link-state-database-overflow-trap – [MIB object: ospfLsdbOverflow]
• link-state-database-approaching-overflow-trap – [MIB object: ospfLsdbApproachingOverflow
To stop an OSPF trap from being collected, use the CLI command: no trap <ospf-trap>, at the
Router OSPF level of the CLI. To disable reporting of the neighbor-state-change-trap, enter the
following command.
BigIron RX(config-ospf-router)# no trap neighbor-state-change-tra
To reinstate the trap, enter the following command.
BigIron RX(config-ospf-router)# trap neighbor-state-change-trap
Syntax: [no] snmp-server trap ospf <ospf-trap>
Enabling OSPF logging
By default, most OSPF logging is enabled (Refer to Table 111 on page 717 for a complete list of the
OSPF default trap settings). If OSPF logging has been previously disabled, you must enable OSPF
logging if you want SNMP traps to be generated for OSPF. Enter commands such as the following.
BigIron RX(config)#router ospf
BigIron RX(config-ospf-router)#log all
Syntax: log all | adjacency | bad_packet | database | memory | retransmit
Enter all to log all OSPF traps generated.
Enter adjacency to log only the traps for adjacency changes
Enter bad_packet to log only those traps for bad packets
Enter memory to log only those traps related to memory issues.
Enter retransmit to log only those traps related to retransmission activities.
NOTE
OSPF retransmit is not logged when log retransmit option is enabled.
Modify OSPF standard compliance setting
The BigIron RX is configured, by default, to be compliant with the RFC 1583 OSPF V2 specification.