Dell PowerConnect B-RX - Modify Default Metric for Redistribution

704 BigIron RX Series Configuration Guide
53-1002253-01
Configuring OSPF
25
FIGURE 107 Redistributing OSPF and static routes to RIP routes
You also have the option of specifying import of just ISIS, RIP, OSPF, BGP4, or static routes, as well
as specifying that only routes for a specific network or with a specific cost (metric) be imported, as
shown in the command syntax below:
Syntax: [no] redistribution bgp | connected | rip | static [route-map <map-name>]
For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following
commands.
BigIron RX(config)# router ospf
BigIron RX(config-ospf-router)# redistribution rip
BigIron RX(config-ospf-router)# redistribution static
BigIron RX(config-ospf-router)# write memory
Modify default metric for redistribution
The default metric is a global parameter that specifies the cost applied to all OSPF routes by
default. The default value is 10. You can assign a cost from 1 – 65535.
RIP Domain
OSPF Domain
ASBR (Autonomous System Border Router)