BigIron RX Series Configuration Guide 1047
53-1002253-01
Displaying sFlow information
39
Displaying sFlow information
Use one of the following commands to display sFlow information.
Display sFlow configuration and statistics
To display sFlow configuration information and statistics, enter the following command at any level
of the CLI.
Syntax: show sflow
This command shows the following information.
TABLE 170 sFlow information
This field... Displays...
sFlow services The feature state, which can be one of the following:
• disabled
• enabled
sFlow agent IP address The IP address that sFlow is using in the agent_address field of packets
sent to the collectors. Refer to “Source address” on page 1039.
Collector The collector information. The following information is displayed for
each collector:
• IP address
• UDP port
If more than one collector is configured, the line above the collectors
indicates how many have been configured.
Polling interval The port counter polling interval.
Configured default sampling rate The configured global sampling rate. If you changed the global sampling
rate, the value you entered is shown here. The actual rate calculated by
the software based on the value you entered is listed on the next line,
”Actual default sampling rate”.
UDP packets exported The number of sFlow export packets the device has sent.
NOTE: Each UDP packet can contain multiple samples.
sFlow samples collected The number of sampled packets that have been sent to the collectors.
sFlow ports The ports on which you enabled sFlow.
Global Sample Rate The global sampling rate for the device.
BigIron RX(config)# show sflow
sFlow services are enabled.
sFlow agent IP address: 30.30.30.2
Collector IP 10.10.10.1, UDP 6343
Polling interval is 20 seconds.
Configured default sampling rate: 1 per 2048 packets.
0 UDP packets exported
0 sFlow samples collected.
sFlow ports Global Sample Rate Port Sample Rate Hardware Sample Rate
3/1 2048 2048 2048
3/2 2048 2048 2048
3/3 2048 2048 2048
3/4 2048 2048 2048
To Next Page
Loading...
