Dell PowerConnect B-RX - Displaying RIP Filters

676 BigIron RX Series Configuration Guide
53-1002253-01
Displaying RIP filters
24
Displaying RIP filters
To display RIP filters, enter the following command at any CLI level.
Syntax: show ip rip
This display shows the following information.
TABLE 108 CLI display of neighbor filter information
This field... Displays...
RIP Summary area Shows the current configuration of RIP on the device.
Stat ic metric Shows the static metric configuration. ".not defined" means the route
map has not been distributed.
OSPF metric Shows what OSPF route map has been applied.
Neighbor filter table area
Index The filter number. You assign this number when you configure the filter.
Action The action the router takes for RIP route packets to or from the specified
neighbor:
• deny – If the filter is applied to an interface’s outbound filter group,
the filter prevents the router from advertising RIP routes to the
specified neighbor on that interface. If the filter is applied to an
interface’s inbound filter group, the filter prevents the router from
receiving RIP updates from the specified neighbor.
• permit – If the filter is applied to an interface’s outbound filter
group, the filter allows the router to advertise RIP routes to the
specified neighbor on that interface. If the filter is applied to an
interface’s inbound filter group, the filter allows the router to
receive RIP updates from the specified neighbor.
Neighbor IP Address The IP address of the RIP neighbor.
BigIron RX> show ip rip
RIP Summary
Default port 520
Administrative distance is 120
updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Last broadcast 30, Next Update 29
Need trigger update 0, next trigger broadcast 1
Minimum update interval 25, Max update offset 5
Split horizon is on; poison reverse is off
import metric 1
Default routes are accepted
Prefix List, Inbound, Not set
Prefix List, Outbound, Not set
Redistribute: CONNECTED Metric : 0 Routemap : Not Set
Static Metric : 1 Routemap : map1 .not defined.
OSPF Metric : 1 Routemap : Not Set
RIP Neighbor Filter Table
Index Action Neighbor IP Address
1 permit any