Dell PowerConnect B-RX - Vrrp;Vrrpe

1380 BigIron RX Series Configuration Guide
53-1002253-01
VRRP/VRRPE
E
VRRP/VRRPE
uplink-switch ethernet <portnum> [to <portnum> |
ethernet <portnum>]
“Configuring uplink ports within a port-based VLAN”
on page 321
vlan <vlan-id> “Configuring port-based VLANs” on page 291
vlan <vlan-id> [by port] “Configuring aggregated VLANs” on page 303
vlan <vlan-id>
[name <vlan-name>]
“Configuring port-based VLANs” on page 291
vlan-group <num> vlan <vlan-id> to <vlan-id> “Configuring a VLAN group” on page 299
Commands See ...
Commands See ...
activate “Configuring the owner” on page 460
“Configuring parameters specific to VRRPE” on
page 462
advertise backup “Backup hello message state and interval” on
page 465
backup [priority <value>] [track-priority <value>] “Configuring parameters specific to VRRPE” on
page 462
“Configuring parameters specific to VRRPE” on
page 462
“Track priority” on page 465
backup-hello-interval <value> “Backup hello message state and interval” on
page 465
clear ip vrrp-stat “Clearing VRRP or VRRPE statistics” on page 473
dead-interval <value> “Dead interval” on page 464
hello-interval <value> “Hello interval” on page 464
ip vrrp auth-type no-auth I
simple-text auth <auth-data>
“Authentication type” on page 463
ip vrrp vrid <num> “Configuring the owner” on page 460
“Configuring parameters specific to VRRPE” on
page 462
“VRRP example” on page 473
ip vrrp-extended vrid <num> “Configuring parameters specific to VRRPE” on
page 462
“VRRPE example” on page 475
ip vrrp-extended auth-type no-auth | simple-text-auth
<auth-data>
“Configuring parameters specific to VRRPE” on
page 462
ip-address <ip-addr> “Configuring the owner” on page 460
“VRRP example” on page 473
non-preempt-mode “Backup preempt” on page 466
owner [track-priority <value>] “Configuring the owner” on page 460
“Track priority” on page 465