Dell PowerConnect B-RX - Stp; Syslog Messages

BigIron RX Series Configuration Guide 1375
53-1002253-01
STP
E
STP
SysLog messages
sflow polling-interval <secs> “Changing the polling interval” on page 1041
sflow sample <num> “Changing the default sampling rate” on page 1042
“Changing the sampling rate on a port” on
page 1043
show sflow “Displaying sFlow information” on page 1047
Commands See ...
Commands See ...
show spanning-tree [vlan <vlan-id>] | [pvst-mode] |
[<num>] |
[detail [vlan <vlan-id> [ethernet <slot/port> ] [|
begin<expression> | exclude<expression> |
include<expression>]
“Displaying STP information for an entire device” on
page 332
show spanning-tree detail [vlan <vlan-id> [ethernet
<slot/port>]]
“Displaying detailed STP information for each
interface” on page 335
show xstp ethernet <slot/port> “Displaying STP information for the specified
Ethernet interface” on page 338
spanning-tree [ethernet <slot/port>] [forward-delay
<value>] | [hello-time <value>] | [max-age <value>] |
[priority <value>]
“Changing STP bridge parameters” on page 329
spanning-tree ethernet <portnum> path-cost <value> |
priority <value> | disable | enable
“Changing STP port parameters” on page 330
spanning-tree single [ethernet <portnum> path-cost
<value> | priority <value>]
“Enabling SSTP” on page 341
spanning-tree single [forward-delay <value>] [hello-time
<value>] | [maximum-age <time>] | [priority <value>]
“Enabling SSTP” on page 341
spanning-tree “Enabling or disabling STP globally” on page 327
“Enabling or disabling STP on a VLAN” on page 328
“Enabling or disabling STP on a port” on page 328
Commands See ...
clear logging [dynamic-buffer | static-buffer] “Displaying the Syslog configuration” on page 1291
“Clearing log entries” on page 1293
Ip show-portname “Displaying the interface name in Syslog messages”
on page 1298
ip show-service-number-in-log “Displaying TCP/UDP port numbers in Syslog
messages” on page 1298