Dell PowerConnect B-RX - Enabling SNMP to Configure RADIUS

BigIron RX Series Configuration Guide 103
53-1002253-01
Configuring RADIUS security
4
Enabling SNMP to configure RADIUS
RADIUS is disabled by default. To enable SNMP access to RADIUS MIB objects on the device, enter
a command such as the following.
BigIron RX(config)#enable snmp config-radius
Syntax: [no] enable snmp <config-radius | config-tacacs>
The <config-radius> parameter specifies the RADIUS configuration mode. RADIUS is disabled by
default.
The <config-tacacs> parameter specifies the TACACS configuration mode. TACACS is disabled by
default.
TABLE 38 Brocade vendor-specific attributes for RADIUS
Attribute name Attribute ID Data type Description
brocade-privilege-level 1 integer Specifies the privilege level for the user. This
attribute can be set to one of the following:
0 Super User level – Allows complete
read-and-write access to the system. This is
generally for system administrators and is the
only management privilege level that allows
you to configure passwords.
4 Port Configuration level – Allows
read-and-write access for specific ports but
not for global (system-wide) parameters.
5 Read Only level – Allows access to the
Privileged EXEC mode and CONFIG mode of
the CLI but only with read access.
brocade-command-string 2 string Specifies a list of CLI commands that are
permitted or denied to the user when RADIUS
authorization is configured.
The commands are delimited by semi-colons
(;). You can specify an asterisk (*) as a
wildcard at the end of a command string.
For example, the following command list
specifies all show and debug ip commands,
as well as the write terminal command:
show *; debug ip *; write term*
brocade-command-exception-flag 3 integer Specifies whether the commands indicated
by the brocade-command-string attribute are
permitted or denied to the user. This attribute
can be set to one of the following:
0 Permit execution of the commands
indicated by brocade-command-string, deny
all other commands.
1 Deny execution of the commands
indicated by brocade-command-string, permit
all other commands.