Dell PowerConnect B-RX - Displaying the IP Route Table

228 BigIron RX Series Configuration Guide
53-1002253-01
Displaying IP information
7
Displaying the IP route table
To display the IP route table, enter the following command at any CLI level.
The show ip route command has been enhanced to include the elapse time since an IP route was
installed.
BigIron RX(config)#show ip route
Total number of IP routes: 2
Type Codes - B:BGP D:Connected I:ISIS S:Static R:RIP O:OSPF; Cost - Dist/Metric
Uptime - Days:Hours:Minutes:Seconds
Destination Gateway Port Cost Type Uptime
1 10.0.0.0/8 10.43.1.1 mgmt 1 1/1 S 2:23:0:16
2 10.43.1.0/24 DIRECT mgmt 1 0/0 D 2:23:0:18
Syntax: show ip route <num> | [<ip-addr> [<ip-mask>] [debug | detail | longer]] | connected |
bgp | isis | ospf | rip | static | summary] [| begin <expression> | exclude <expression> |
include <expression>]
Type The type of host entry, which can be one or more of the following:
• D – Dynamic
• P – Permanent
• F – Forward
• U – Us
• C – Complex Filter
• W – Wait ARP
• I – ICMP Deny
• K – Drop
• R – Fragment
• S – Snap Encap
Port The port through which this device reaches the destination. For
destinations that are located on this device, the port number is shown as
“n/a”.
VLAN Indicates the VLANs the listed port is in.
Pri The QoS priority of the port or VLAN.
TABLE 55 CLI display of IP forwarding cache (Continued)
This field... Displays...
BigIron RX> show ip route
Total number of IP routes: 514
Start index: 1 B:BGP D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination Gateway Port Cost Type
1.1.0.0 99.1.1.2 1/1 2 R
1.2.0.0 99.1.1.2 1/1 2 R
1.3.0.0 99.1.1.2 1/1 2 R
1.4.0.0 99.1.1.2 1/1 2 R
1.5.0.0 99.1.1.2 1/1 2 R
1.6.0.0 99.1.1.2 1/1 2 R
1.7.0.0 99.1.1.2 1/1 2 R
1.8.0.0 99.1.1.2 1/1 2 R
1.9.0.0 99.1.1.2 1/1 2 R
1.10.0.0 99.1.1.2 1/1 2 S