Dell PowerConnect B-RX - Displaying the Active MBGP Configuration

864 BigIron RX Series Configuration Guide
53-1002253-01
Displaying MBGP information
27
Syntax: show ip mbgp summary
NOTE
This command’s display looks similar to the display for the show ip bgp config command. However,
the show ip mbgp config command lists only the MBGP neighbors, whereas the show ip bgp config
command lists only the BGP neighbors.
Displaying the active MBGP configuration
To display the active MBGP configuration information contained in the running-config without
displaying the entire running-config, enter the following command at any level of the CLI.
Syntax: show ip mbgp config
NOTE
This command displays exactly the same information as the show ip bgp config command. Each
command displays both the BGP and MBGP configuration commands that are in the running-config.
BigIron RX# show ip mbgp summary
BGP4 Summary
Router ID: 9.9.9.1 Local AS Number : 200
Confederation Identifier : not configured
Confederation Peers:
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 5677
Number of Routes Advertising to All Neighbors : 5673
Number of Attribute Entries Installed : 3
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
166.1.1.2 200 ESTAB 0h24m54s 3 0 5673 0
BigIron RX# show ip mbgp config
Current BGP configuration:
router bgp
local-as 200
neighbor 166.1.1.2 remote-as 200
address-family ipv4 unicast
no neighbor 166.1.1.2 activate
exit-address-family
address-family ipv4 multicast
redistribute connected
redistribute static
neighbor 166.1.1.2 activate
exit-address-family
address-family ipv6 unicast
exit-address-family
end of BGP configuration