Dell PowerConnect B-RX - Displaying Ospfv3 Database Information

1228 BigIron RX Series Configuration Guide
53-1002253-01
Displaying OSPFv3 information
48
Syntax: show ipv6 ospf area [<area-id>]
You can specify the <area-id> parameter in the following formats:
• As an IPv4 address, for example, 192.168.1.1
• As a numerical value from 0 – 2,147,483,647
The <area-id> parameter restricts the display to the specified OSPF area
This display shows the following information.
Displaying OSPFv3 database Information
You can display a summary of the Brocade device’s link state database or detailed information
about a specified LSA type.
To display a summary of a device’s link state database, enter the following command at any CLI
level.
TABLE 211 OSPFv3 area information fields
This field... Displays...
Area The area number.
Interface attached to this area The router interfaces attached to the area.
Number of Area scoped LSAs Number of LSAs with a scope of the specified area.
SPF algorithm executed The number of times the OSPF Shortest Path First (SPF) algorithm is executed
within the area.
SPF last updated The interval in seconds that the SPF algorithm was last executed within the
area.
Current SPF node count The current number of SPF nodes in the area.
Router Number of router LSAs in the area.
Network Number of network LSAs in the area.
Indx The row number of the entry in the router’s OSPF area table.
Area The area number.
Maximum hop count to nodes. The maximum number of hop counts to an SPF node within the area.
BigIron RX# show ipv6 ospf area
Area 0:
Interface attached to this area: loopback 2 ethe 3/2 tunnel 2
Number of Area scoped LSAs is 6
Statistics of Area 0:
SPF algorithm executed 16 times
SPF last updated: 335256 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
...