BigIron RX Series Configuration Guide 893
53-1002253-01
Displaying IPv4 IS-IS information
28
Displaying interface information
To display information about the device’s IS-IS interfaces, enter the following command at any level
of the CLI.
TABLE 136 IS-IS Syslog messages
Message level Message Explanation
Alert ISIS MEMORY USE EXCEEDED IS-IS is requesting more memory than is
available.
Notification ISIS L1 ADJACENCY DOWN <system-id> on
interface <interface-id>
The device’s adjacency with this Level-1 IS
has gone down.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
Notification ISIS L1 ADJACENCY UP <system-id> on
interface <interface-id>
The device’s adjacency with this Level-1 IS
has come up.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
Notification ISIS L2 ADJACENCY DOWN <system-id> on
interface <interface-id>
The device’s adjacency with this Level-2 IS
has gone down.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
Notification ISIS L2 ADJACENCY UP <system-id> on
interface <interface-id>
The device’s adjacency with this Level-2 IS
has come up.
The <system-id> is the system ID of the IS.
The <interface-id> is the ID of the interface
over which the adjacency was established.
Notification ISIS ENTERED INTO OVERLOAD STATE The device has set the overload bit to (1),
indicating that the device’s IS-IS resources
are overloaded.
Notification ISIS EXITED FROM OVERLOAD STATE The device has set the overload bit to off (0),
indicating that the device’s IS-IS resources
are no longer overloaded.
To Next Page
Loading...
