1230 BigIron RX Series Configuration Guide
53-1002253-01
Displaying OSPFv3 information
48
For example, to display detailed information about all LSAs in the database, enter the following
command at any CLI level.
Seq(Hex) The sequence number of the LSA. The OSPF neighbor that sent the LSA stamps it with
a sequence number to enable the Brocade device and other OSPF routers to determine
which LSA for a given route is the most recent.
Age The age of the LSA, in seconds.
Chksum A checksum for the LSA packet. The checksum is based on all the fields in the packet
except the age field. The Brocade device uses the checksum to verify that the packet is
not corrupted.
Len The length, in bytes, of the LSA.
TABLE 212 OSPFv3 database summary fields (Continued)
This field... Displays...
To Next Page
Loading...
