BigIron RX Series Configuration Guide 1263
53-1002253-01
IPv6 PIM sparse
49
This example show information displayed on a device that is a candidate RP. The following example
shows the message displayed on a device that is not a candidate RP.
BigIron RX# show ipv6 pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ipv6 pim rp-candidate
This display shows the following information.
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
BigIron RX# show ipv6 pim rp-map
Idx Group address RP address
--------------------------------------------------------------------------------
1 ff1e::1:2 2001:3e8:255:255::17
2 ff7e:a40:2001:3e8:27:0:1:2 2001:3e8:27::a
3 ff7e:140:2001:3e8:16:0:1:2 2001:3e8:16::1
BigIron RX#
Syntax: show ipv6 pim rp-map
This display shows the following information.
This field... Displays...
Candidate-RP-advertisement in Indicates how many seconds will pass before the BSR sends its next RP
message.
NOTE: This field appears only if this device is a candidate RP.
RP Indicates the IPv6 address of the Rendezvous Point (RP).
NOTE: This field appears only if this device is a candidate RP.
group prefixes Indicates the multicast groups for which the RP listed by the previous field
is a candidate RP.
NOTE: This field appears only if this device is a candidate RP.
Candidate-RP-advertisement period Indicates how frequently the BSR sends candidate RP advertisement
messages.
NOTE: This field appears only if this device is a candidate RP.
This field... Displays...
Index The index number of the table entry in the display.
Group address Indicates the IPv6 PIM Sparse multicast group address using the listed RP.
RP address Indicates the Iv6 address of the Rendezvous Point (RP) for the listed PIM
Sparse group.
BigIron RX# show ipv6 pim rp-candidate
Next Candidate-RP-advertisement in 00:00:10
RP: 1be::11:21
group prefixes:
ff00:: / 8
Candidate-RP-advertisement period: 60
To Next Page
Loading...
