1280 BigIron RX Series Configuration Guide
53-1002253-01
Configuring a IPv6 multicast route
50
BigIron RX(config)# ipv6 mroute 12.7.1.0 255.255.255.0 17.3.1.2
Syntax: [no] ipv6 mroute <ip-addr> <ip-mask> [<next-hop-ip-addr> | ethernet <slot/port> | ve
<num> | null0] [<cost>] [distance < num>]
The ip-addr and ip-mask parameters specifies the PIM source for the route.
The ethernet <slot/port> parameter specifies a physical port.
The ve <num> parameter specifies a virtual interface.
The null0 parameter is the same as dropping the traffic.
The distance <num> parameter sets the administrative distance for the route.
The <cost> parameter specifies the cost metric of the route. Possible values are: 1 - 6 Default
value: 1.
Regardless of the administrative distances, the BigIron RX Series Router always prefers directly
connected routes over other routes.
To Next Page
Loading...
