Dell PowerConnect B-RX - Page 1431

BigIron RX Series Configuration Guide 1355
53-1002253-01
Multicast (IP)
E
message-interval <num> “Changing the PIM join and prune message interval”
on page 615
ip mroute <ip-addr> <ip-mask> [<next-hop-ip-addr> |
ethernet <slot/port> | ve <num> | null0] [<cost>]
[distance < num>] }
“Configuring a static multicast route” on page 655
nbr-timeout “Modifying neighbor timeout” on page 602 (PIM)
“Modifying neighbor timeout” on page 652 (DVMRP)
probe-interval <5-30> “Modifying probe interval” on page 653
prune-age <20-3600> “Modifying prune age” on page 652
prune-timer <10-3600> “Modifying prune timer” on page 603
prune-wait <time> “Modifying the prune wait timer” on page 603
report-interval <10-2000> “Enabling DVMRP on an interface” on page 651
route-discard-timeout <40-8000> “Modifying route discard time” on page 652
route-expire-timeout <20-4000> “Modifying route expires time” on page 652
router dvmrp “Globally enabling and disabling DVMRP” on
page 651
router pim “Globally enabling and disabling PIM” on page 601
“Configuring global PIM Sparse parameters” on
page 608
rp-address <ip-addr> “Statically specifying the RP” on page 610
rp-candidate add I delete <group-addr> <mask-bits> “Configuring RPs” on page 609
rp-candidate ethernet <slot>/<portnum> | loopback
<num> | ve <num>
“Configuring RPs” on page 609
show ip pim | dvmrp rpf <IP address> “Displaying information about an upstream neighbor
device” on page 655
“Displaying information about an upstream neighbor
device” on page 622
show ip pim bsr “Displaying BSR information” on page 618
show ip pim dense “Viewing the prune wait time” on page 603
show ip pim group “Displaying a list of multicast groups”
on page 617
show ip pim mcache “Displaying the PIM multicast cache” on page 623
show ip pim nbr “Displaying multicast neighbor information” on
page 621
show ip pim rp-candidate “Displaying candidate RP information” on page 619
show ip pim rp-hash <group-addr> “Displaying RP information for a PIM Sparse group”
on page 620
show ip pim rp-map “Displaying RP-to-group mappings” on page 620
show ip pim rp-set “Displaying the RP set list” on page 621
show ip pim sparse “Displaying basic PIM Sparse configuration
information” on page 616
show ip pim traffic “Displaying PIM traffic statistics” on page 625
Commands See ...