1364 BigIron RX Series Configuration Guide
53-1002253-01
Security/Management
E
auth-fail-max-attempts <attempts> “Specifying the number of authentication attempts
the device makes before dropping packets” on
page 981
auth-fail-vlanid <vlan-id> “Specifying the authentication-failure action” on
page 981
clear dot1x mac-session <mac-address> “Clearing a dot1x-mac-session for a MAC address” on
page 982
clear dot1x statistics all I <portnum> “Clearing 802.1x statistics” on page 986
dot1x filter-strict-security “Disabling and enabling strict security mode for
dynamic filter assignment” on page 973
dot1x initialize <portnum> “Initializing 802.1x on a port” on page 980
dot1x port-control [force-authorized | force-unauthorized |
auto]
“Setting the port control” on page 977
dot1x re-authenticate <portnum> “Re-authenticating a port manually” on page 978
dot1x-enable “Enabling 802.1x port security” on page 976
enable all I<portnum> [to <portnum> ] “Enabling 802.1x port security” on page 976
global-filter-strict-security “Disabling and enabling strict security mode for
dynamic filter assignment” on page 973
maxreq <value> “Specifying the number of EAP-request/identity
frame retransmissions” on page 979
radius-server host <ip-addr> | <server-name> [auth-port
<number> acct-port <number> [authentication-only |
accounting-only | default [key 0 | 1 <string> [dot1x]]] ]
“Setting RADIUS parameters” on page 971
re-authentication “Configuring periodic re-authentication” on page 978
servertimeout <seconds> “Specifying a timeout for retransmission of messages
to the authentication server” on page 980
show dot1x “Displaying 802.1x configuration information” on
page 982
show dot1x config ethernet <slot/port> “Displaying 802.1x configuration information” on
page 982
show dot1x ip-acl [all | ethernet <slot/port> | | begin
<expression> | exclude <expression>
| include
<expression>]
“Displaying IP ACLs applied to an 802.1x-enabled
port” on page 987
show dot1x mac-address-filter [all | ethernet <slot/port>
[begin <expression> | exclude <expression> | include
<expression>]]
“Displaying MAC address filters applied to an
802.1x-enabled port” on page 987
show dot1x mac-session [brief [begin <expression> |
exclude <expression> | include <expression>]]
“Displaying information about the
dot1x-mac-sessions on each port” on page 988
“Displaying information about the ports in an 802.1x
multiple client configuration” on page 989
show dot1x statistics [all | ethernet <slot/port>] “Displaying 802.1x statistics” on page 984
supptimeout <seconds> “Specifying a timeout for retransmission of
EAP-request frames to the client” on page 980
timeout quiet-period <seconds> “Setting the quiet period” on page 979
Commands See ...
To Next Page
Loading...
