BigIron RX Series Configuration Guide 125
53-1002253-01
Specifying a Simple Network Time Protocol (SNTP) server
5
To display information about SNTP status, enter the following command.
Syntax: show sntp status
The following table describes the information displayed by the show sntp status command.
TABLE 41 Output from the show sntp associations command
This field... Displays...
(leading character) One or both of the following:
* Synchronized to this peer
~ Peer is statically configured
address IP address of the peer
ref clock IP address of the peer’s reference clock
st NTP stratum level of the peer
when Amount of time since the last NTP packet was received from the peer
poll Poll interval in seconds
delay Round trip delay in milliseconds
disp Dispersion in seconds
TABLE 42 Output from the show sntp status command
This field... Indicates...
unsynchronized System is not synchronized to an NTP peer.
synchronized System is synchronized to an NTP peer.
stratum NTP stratum level of this system
reference clock IP Address of the peer (if any) to which the unit is synchronized
precision Precision of this system's clock (in Hz)
reference time Reference time stamp
clock offset Offset of clock to synchronized peer
root delay Total delay along the path to the root clock
root dispersion Dispersion of the root path
peer dispersion Dispersion of the synchronized peer
BigIron RX# show sntp status
Clock is synchronized, stratum = 2, reference clock = 207.95.6.102
precision is 2**-16
reference time is 3472592840.0
clock offset is 225.21829605 msec, root delay is 0.000 msec
root dispersion is 0.000 msec, peer dispersion is 0.000 msec
round trip delay is 450.43659210 msec
sntp poll-interval is 1800 secs
To Next Page
Loading...
