BigIron RX Series Configuration Guide xliii
53-1002253-01
Rate Limiting Port-based, port-and-priority based, port-and-vlan-based, and
port-and-ACL-based rate limiting on inbound ports are supported.
SuperSpan A Brocade STP enhancement that allows Service Providers (SPs) to
use STP in both SP networks and customer networks.
Topology Groups A named set of VLANs that share a Layer 2 topology. You can use
topology groups with the following Layer 2 protocols:
• STP
• Brocade MRP
• VSRP
• 802.1W
Trunk Groups and LAG Allows you to manually configure multiple high-speed load-sharing
links between two Brocade devices or between a Brocade device and
a server.
VLANs 802.1Q tagging
Port-based VLANs
Super Aggregated VLANs (SAV)
Dual-mode VLAN ports
Transparent Port Flooding
VLAN ID to MSTP Instance Pre-assignment
Private VLANs
VSRP Layer 2 Virtual Switch Redundancy Protocol (VSRP)
Layer 3 Virtual Switch Redundancy Protocol (VSRP)
VSRP and MRP Signaling
Layer 2 ACLs Replaces MAC filters
Layer 2 PIM Snooping
Layer 3 features
ACLs Standard, Extended and Super
Inbound
ACL logging
ACL editing
BGP BGP routes
BGP peers
BGP dampening
Graceful Restart
FDR Foundry Direct Routing
IP Forwarding IPv4 Routing
IPv6 Routing
IP Static entries Routes
ARPs
Virtual interfaces
Secondary addresses
IS-IS
TABLE 1 Supported features (Continued)
Category Feature description
To Next Page
Loading...
