Dell PowerConnect B-RX - Page 573

BigIron RX Series Configuration Guide 497
53-1002253-01
Scheduling traffic for forwarding
18
Syntax: qos scheduler max-rate <Queue0-rate> <Queue1-rate> <Queue2-rate> <Queue3-rate>
The <Queue0-rate> variable defines the maximum bandwidth allocated to forwarding queue 0 in
Kbps.
The <Queue1-rate> variable defines the maximum bandwidth allocated to forwarding queue 1 in
Kbps.
The <Queue2-rate> variable defines the maximum bandwidth allocated to forwarding queue 2 in
Kbps.
The <Queue3-rate> variable defines the maximum bandwidth allocated to forwarding queue 3 in
Kbps.
Configuring minimum rate-based traffic scheduling
To configure minimum rate-based scheduling use a command such as the following.
BigIron RX(config)# interface ethernet 1/1
BigIron RX(config-if-e1000-1/1)# qos min-rate 100 100 100 100
Syntax: qos scheduler min-rate <Queue0-rate> <Queue1-rate> <Queue2-rate> <Queue3-rate>
The <Queue0-rate> variable defines the minimum bandwidth allocated to forwarding queue 0 in
Kbps.
The <Queue1-rate> variable defines the minimum bandwidth allocated to forwarding queue 1 in
Kbps.
The <Queue2-rate> variable defines the minimum bandwidth allocated to forwarding queue 2 in
Kbps.
The <Queue3-rate> variable defines the minimum bandwidth allocated to forwarding queue 3 in
Kbps.
Displaying the scheduler configuration
To view a Scheduler configuration, use the following command.