lx BigIron RX Series Configuration Guide
53-1002253-01
IPv6 Load Sharing over ECMP
and Trunks
When the device receives traffic for a destination,
and the IPv6 route table contains multiple,
equal-cost paths to that destination, the packets
are load balanced between multiple next-hops
including member ports of a trunk.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring
Basic IPv6 Connectivity”
Section: “ECMP load
sharing for IPv6”
Directly Attached Host
Resource Allocation
The CAM allocations can be re-distributed using the
cam-partition next-hop command.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring
Basic Parameters”
Section: “Re-distributing
CAM allocations”
Multicast Boundaries The Multicast Boundary feature is designed to
selectively allow or disallow multicast flows to
configured interfaces.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring IP
Multicast Protocols”
Section: “IP multicast
boundaries”
IPv6 PIM-SM Book: Foundry BigIron RX
Configuration Guide
Chapter:
Section:
Embedded RP Embedded RP allows the router to learn RP
information using the multicast group destination
address instead of the statically configured RP.
Book: Foundry BigIron RX
Configuration Guide
Chapter:
Section:
MLD Snooping Book: Foundry BigIron RX
Configuration Guide
Chapter:
Section:
MBGP for IPv6 This release supports the Multi-protocol Border
Gateway Protocol (MBGP) for IPv6.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring IPv6
MBGP”
IPv6 mroute This release supports multicast route table ipv6
multicast display and management.
Book: BigIron RX Series
Configuration Guide
Chapter: “Configuring IPv6
Routes”
Section: “Configuring a
IPv6 multicast route”
IPv6 MulticastRoute Table
Manager
Book: Foundry BigIron RX
Configuration Guide
Chapter: TBD
Section: TBD
Multicast MLL Sharing Book: Foundry BigIron RX
Configuration Guide
Chapter: TBD
Section: TBD
TABLE 12 Summary of enhancements in release 02.4.00 (Continued)
Enhancement Description See page
To Next Page
Loading...
