44
Profile limits: Enter normal ranges for Human, Male, Female, and Alternate 1 and 2 profile limits
X-B: Change X-B limits and targets
User: Add and manage users of the ‘Abacus 5’ analyzer (only available to administrator users)
Delete user: Initiates deletion of a user account
Administrator: Selects or unselects administrator privileges for the currently selected user
See section 1 for more information about ‘Abacus 5’ analyzer user settings
Cleaning: Perform extended cleaning of various pneumatic components
Draining: Drain various internal system reservoirs
Empty chamber: Empty RBC, WBC, and mix chambers
Prime: Prime one or all reagent reservoirs
Fill: Fills the fluidic components of the system with reagents
Touchscreen: Calibrate the touchscreen location for taps and button presses
See section 1 for more information about ‘Abacus 5’ maintenance procedures
Calibration mode: Select type of calibration procedure to run
Calibration type: Select human blood or calibrator material
Target values: Enter the target ranges for each calibrated parameter
Cancel: Cancels a calibration procedure
Next: Initiates processing of calibration run
View calibrations: View and delete previous calibrations
See section 1 for more information about ‘Abacus 5’ calibration
QC Measure: Initiate processing of a control sample
QC Reference select: Select which stored QC reference this measurement belongs to
Set QC Reference: Create a new stored QC reference
Load QC reference: load QC reference values from removable media such as a flash drive
Save reference: Save entered QC reference values
View QC references: Browse stored QC references
Delete: Delete a stored QC reference
Details: View detailed results for a stored QC reference
View QC data: Browse individual QC sample measurements
Delete: Delete currently selected QC run
View QC diagrams: View QC diagrams for currently selected
Details: View detailed result screen of a QC run
View QC diagrams: View Levy-Jennings diagrams of QC data for the currently selected QC reference
View QC data: Browse individual QC sample measurements
Next diagrams: Browse the next set of QC diagrams
View X-B data: Browse individual X-B sample measurements
Reject: Reject a run from being included in X-B calculations
View rejected: View previously rejected X-B runs
Undo reject: Restore a previously rejected X-B run and use in X-B calculations
View X-B diagrams: Navigate directly to X-B diagrams
View X-B diagrams: View X-B diagrams of X-B data
See section 1 for more information about quality control on the ‘Abacus 5’ analyzer
Selftest: Perform electronic and/or pneumatic system self tests
Load last selftest: Loads the results of the last selftest
Start electronic: Starts the electronic tests
Start both: Starts both electronic and pneumatic tests
Log: Review and obtain additional details about events in the system log
Details: Display details about the selected event in the event log
Selftest: Navigates directly to self test screen
To Next Page
Loading...
