A-8
Appendix A
The action of the button can be a single function or a combination of several functions and these can be entered in two ways.
1) Perform a function on the worksurface such as muting a channel and the control message will appear in the Last control ID read box
on the panel. You can then position the cursor in either the ON or OFF text box and press the Copy To Script button to transfer the
message. The process can then be repeated for other controls
Note: This procedure does not work for all console functions, if the controller is not read the script wmust be entered manually.
2) Type the messages with the correct syntax directly into the ON and/or OFF text boxes.
The most common examples are shown at the top of the panel.
A full list of these messages can be found in the file called D5Setup.rtf in the console's D5T or D5TC directory.
To Next Page
Loading...
