Chapter 4
| System Management Commands
File Management
– 104 –
General Commands
boot system This command specifies the file or image used to start up the system.
Syntax
boot system {boot-rom | config | opcode}: filename
boot-rom* - Boot ROM.
config* - Configuration file.
opcode* - Run-time operation code.
filename - Name of configuration file or code image.
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ A colon (:) is required after the specified file type.
◆ If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir (108)
whichboot (109)
upgrade opcode reload Reloads the switch automatically after the opcode upgrade
is completed
GC
show upgrade Shows the opcode upgrade configuration settings. PE
Table 15: Flash/File Commands (Continued)
Command Function Mode
To Next Page
Loading...
